Repair a noisy automatic garage door

Noisy appliances can be a very annoying, especially when it is something that you tend to use quite often. Noisy automatic garage doors are an example of such situations, as you use the garage every day to get to your car. Don’t worry it’s not a serious issue and you can fix it yourself without calling a professional.

Tighten loose parts

Before you start, make sure that all the parts of the door are securely fitted to their respective places. Tighten all the screws and nuts on and around the door using a deep socket wrench and a ratchet. However, you need to be careful when tightening the nuts and make sure that you don’t over tighten them as you may end up ruining their threads or even damaging the material they are screwed on to.

Hinge and roller maintenance

The unpleasant noise might be caused by worn out rollers and hinges. Nothing lasts forever so like everything; these parts also get damaged with time. They also may become worn due to dust in the garage’s environment or humidity in the air that eventually leads to the rusting of rollers and hinges. When the wear becomes excessive, the rollers often shake and wobble as the door closes and opens.

If this is the case, you need to replace them. The best option is nylon rollers that come with sealed bearings. These are more quiet, efficient and don’t necessarily require periodic oiling like the steel bearings. You can buy them at your local hardware store in Sydney. However, you should note that they are more expensive in comparison to the regular steel bearings.

Loose garage door chain

You also need to check the garage door chain that opens and closes the door. A loose chain is responsible for most of the noise and the jerky movements the door makes as it operates. The jerky movements, in turn, are responsible for thrashing the rollers onto their tracks. Tighten the chain to minimise the noise the door makes, will also solve the roller smacking problem that would have eventually led to damaged rollers.

Once this is done, you need to apply grease onto the chain to facilitate easier movement as the door opens and closes. The lubricant will also reduce the wear on the chain itself, thus prolonging its lifespan. Spray the bearings, hinges and springs with a garage door lubricant.

However, if you by any chance get stuck and aren’t sure if you can repair your garage door yourself. Contact Automatic Garage Solutions.

We are here to help with any automatic garage door repairs.

Content Source Repair a noisy automatic garage door

How to care for your garage roller door

These days garage roller doors are, more than ever, made from hardy and durable materials. For example, many modern roller doors are constructed from colorbond steel; a material known for its excellent performance.

However, like all parts of your home, your garage door will require maintenance to keep it working at its best. In this month’s article, we would like to advise you on how to clean your roller door. So you can ensure that your garage door looks great for a long time.

1. Wash your garage door regularly

How often you should wash your garage door will predominantly depend on where you live, and how often you use it. Those living in dry and humid regions, for example, are encouraged to clean more often than those living in areas where rain is common like Sydney.

2. Don’t let the dirt build up

Things such as dirt, and grime build-ups and harden over time becoming increasingly difficult to remove. Therefore it’s wise to remove them as soon as possible. A little work now can save you a lot of time and money in future.

3. Rinse your garage door first

Before applying detergents to your door, give it a rinse with cold water. You can use a hose or bucket of water; either will be fine. This will help to prevent abrasions or damage during the cleaning process.

4. Rinse your roller garage door after cleaning

Just like when doing the dishes, it’s important to finish by rinsing off excess detergent. Simply spray your door until all the leftover cleaning product has been removed. The same like with rinsing before cleaning, use a hose or bucket of fresh water.

5. Wash your roller door with warm soapy water

The best way to clean your garage door is with a bucket of warm soapy water and a sponge. Non-abrasive cleaners and gentle detergents are in most cases sufficient to remove dirt and they won’t damage your door.

6. Always read the manufacturer’s instruction

Some roller doors and roller door parts may require certain cleaning methods or products. So before cleaning a new door for the first time, it is a good idea to read the manufacturer’s instructions.

7. Don’t forget to wash the back of your garage door

While only one side of your garage door will be exposed to the elements, both sides will eventually need cleaning. So don’t forget, when cleaning your roller door, clean both its interior and exterior

8. Don’t wash the garage door motor

While it may be tempting, when you’ve got the hose out, to spray the garage motor, it is highly advised not to do so. Soaking your door motor could cause failures, and loss of warranty.

We hope you found this article helpful.

If you have any questions, don’t hesitate to contact us regarding your garage roller door in Sydney!

Content Source How to care for your garage roller door

Timber or timber- look garage doors?

So you decided to buy a timber garage door – Congratulations, it’s a great choice!

A natural wood finish will definitely add class to your property.

However, if you still haven’t made up your mind, we strongly recommend this article for you to find out all pros and cons of timber and timber look garage doors.

Both timber and timber-look doors offer a number of unique benefits. Based on your situation and what you’re looking for in a garage door, one or the other may be a more practical or more cost-effective solution.

1. Timber-look garage doors are low maintenance

As the name suggests, timber-look garage doors look just like timber doors. However, unlike timber doors, they are constructed from synthetic materials and metal.

There are several key benefits of using steel as opposed to timber. For many, the biggest benefit is that steel doesn’t require much maintenance. It’s strong and durable, with no need for resealing.

2. Timber garage doors are made from real wood

Timber-look garage doors look great, they’re often more cost effective, and they require significantly less maintenance. However, for some homeowners, there is simply no substitute for the natural look and feel of real wood timber.

3. Timber-look garage doors are cheaper

One of the benefits of using alternative materials is that it often lowers production costs. Lower production costs mean a lesser retail price-tag for consumers.

4. Timber-look garage doors are termite & rot resistant

Because there’s no timber for the termites to get their nasty teeth into, timber-look garage doors are completely termite resistant. Timber-look doors also won’t rot, warp or split. They’re also generally made from non-combustible materials.

Because timber-look garage doors are made from hardy and long last materials, often the only maintenance required is the occasional wash with soap and water. As well as, like all garage doors, an annual service.

Whichever you choose, you’re sure to love your new garage door.

If you’d like to find out more about any type of garage doors, don’t hesitate contact Automatic Garage Solutions.

Content Source Timber or timber- look garage doors?